I was thinking about an electronic toothbrush, or a kettle?
7,099 karma · joined February 27, 2012
Building a community of retro advert lovers on Twitter
https://twitter.com/OldTechAdverts
I was thinking about an electronic toothbrush, or a kettle?
With this setup, you can...
* create a BASIC program right at the command prompt
* execute instructions to read and write to mass storage.
* debug your BASIC program at the command prompt
* direct access to memory addresses via peek and poke commands
For circuit board design we are missing * PCB layer management
* copper dimensioning
* track management
* Design rules management
* many others....
At best, I would describe this tool as a vim for schematic capture in its current iteration.
One question to the founders, what are the real pain points for you that atopile are relieving?
Joking aside, how would you use this tool for your private tasks?
Some stories are short and straight to the point.
I had a colleague where if the analogies are used to as part of the story told, the message is not full understood by him.