These new technologies/products try to solve the problem from both ends. Increasing transmit power to the max allowed. Some early Zigbee chips for instance had transmit powers of 0db, big fail. These new radios transmit 10 to 20 db output power. On the receive side reduce bandwidth to increase the sensitivity by 10-30 db, at the expense of data rate.
The cost of all this is very low bandwidth. Not just in bps, but also packets per minute due to duty cycle regulations. This poses some problems if you want encrypt your packets. Add at least 32-64 bytes overhead. Another problem is as the coverage area gets wider so does the number of interfering radio's.
+ Sometimes you hear comments that spread spectrum allows you operate below the noise floor, but that's only for the spread signal. Once the signal is despread at the receiver, same rules apply.
That means that with an 11Kbps line you are getting about 1,000 characters per second once you factor in other communication over head (stop bits, parity bits, etc). While this may sound fast it is painfully slow for anything other than typing in single line commands and reading single line responses. The transfer of a blank 4KB text file will take three seconds. The transfer of a plain text file the size of a book would take a few minutes.
With the additional overhead of SSH you will actually see the characters appearing on the screen like a lame 80s hacker movie.