Yes, this does look like (from the demo video results), a decent driver design, however quality of the motor DOES matter, and will eventually become a limiting factor if you are lookig for high precision or high power, as you start to run into things like torque digging, motor heating, etc. There are also little things in the driver design that can bite you if you aren't careful, but I'd need to look at the schematics to comment.
I'm not trying to crap on the project or designer. There was clearly some thought and care put into this! I just don't want people to expect magic, or to think that the only difference between an industrial servo and a hobbyist motor is the electronics. That said, you can get VERY far with good electronics and control software!
A hobbyist project will probably do just fine with something like this (or a motor driver reference design from the chip manufacturers), and by the time they run into limits of those designs and hobbyist motors, they'll probably have a pretty good idea of where they need to go as a next step!
I'll take a closer look at this design later, and update if anyone is interested.