As said above, the chance of a meltdown is slim as sodium is a solid at room temp, therefore you don't have to worry about it ever boiling off. It would have prevented a Fukushima type meltdown, but sodium is extremely reactive and had the sodium touched water, you would have had huge explosions. Their test loop in Argonne had to go through extreme welding checks to prevent possible humidity from getting in. Salt also has better heat transfer properties than water. Interestingly, research in this area really stagnated, and its only recently gotten attention. The US went all in on water due to the nuclear navy.
The open-sourced design uses molten salt, which is the very stable stuff you probably have in a shaker on your kitchen table.
FLiBe is more corrosive to steel but there are advanced alloys that withstand it fairly well.
Another approach is to use a modular design that makes it easy to replace parts before they corrode too much. Thorcon and Terrestrial Energy use small reactor cores that get replaced every few years.
It's also really easy to halt meltdowns - since the fuel and coolant are a big liquid glob, you can have thermal plugs that will melt above a certain temperature and drain the coolant+fuel into tubes small enough that, even when the small tubes are full, the coolant+fuel in the tubes is below critical mass and the reaction stops. It fails safe and is immune to mechanical failure, unlike control rods in current reactor designs that have to be moved in and out.
A pipe leak in the reactor itself doesn't create a lot of gas. It's molten salt at atmospheric pressure. It drips out and solidifies as it cools. An advantage of MSRs is that the troublesome fission products (like iodine, cesium, and strontium) don't leak out as gases, like they do from conventional reactor cores; instead they are chemically bound in the salt.
It’s another issue that feels like the answer involves new materials that have a much longer life in situ, so that the inevitable maintence is infrequent. It’s a very promising technology, but it isn’t mature yet.
Terrestrial Energy and Thorcon use small sealed reactor cores that get replaced every few years.
Moltex uses a pool design, where everything is immersed from above in a pool of coolant salt, and can be pulled out and replaced as necessary. The actual fuel is isolated in vertical rods.
At least three companies use chloride salts. According to a presenter from Elysium, in the absence of water the chloride salt is less corrosive to stainless steel than water is.
I certainly agree that the technology isn't mature, since we don't have any production reactors yet. But we're making good progress, especially in Canada where regulation of new nuclear technology is more rational than in the U.S.
On the other hand, working with a big pool of radioactive liquid that will literally explode and catch fire if it comes in contact with water and still catches fire if it comes in contact with air may also be ... challenging.
The lack of any sort of driver for chemical explosions is one of the advantages of molten salt reactors over light water reactors, in which the water can split into oxygen and hydrogen and cause explosions (as we saw at Fukushima).
Do you have any examples of liquid-fueled reactors using NaK?
Some MSR companies are working on fast reactors using chloride salts, including Moltex, Elysium, and Terrapower (in a project separate from their better-known sodium-cooled fast reactor).
High temperature is a property of all MSRs I know of and does have some advantages, including better thermodynamic efficiency and usefulness for process heat.