As far as either of us know, it's common knowledge among anyone other than the 'katanas can cut steel beams' crowd that Japan was very very iron-poor, was alloying-elements-poor, that their folding technique was not unique by any means, and that noone including Japan sharpened swords to a single molecule's thickness on the cutting edge for good reasons relating to durability. (You could, if you wanted to, fairly trivially sharpen your kitchen knives at least near that degree. You wouldn't want to, for the same durability reason.)
My wife is now professionally a neuroscientist, and they do use scalpels that precisely sharp, or even sharpened tungsten wire 'grown' chemically into that configuration for precision work like cutting into a single cell of your choice under high power microscopy. But all of those are nearly single-use-only instruments. To the extent they can be reused, it's because they only touched very soft cellular material and never contacted something anywhere as hard as a cutting board, much less a bone -- as both kitchen knives and combat swords would do routinely in use. You really don't want the tip of your blade folding over upon itself, which happens almost immediately with a blade that thin. If curious on this topic, investigate the advantages of a beveled (multi-angle) grind, common on a chef's knife, vs a hollow ground edge like you might find on a santoku kitchen knife -- particularly pay attention to the difference in maintenance required of each.
I expect googling for 'japan iron-poor' and 'sword folding technique' would immediately shed light on either of those areas, if you're still in search of a citation.