There is no "absolute fashion" of avoiding bad conditions in any discipline of engineering. There are just different modes of failure that need to be considered.
In the case of software, you would start with a Hazard Analysis. Designs/code that have high hazard (failure may mean serious injury or death for example) get more scrutiny and better protection. A simple example might be you that have to make a complex calculation that could be catastrophic if it is buggy. That might be mitigated by breaking up the calculation into segments and error checking each segment (e.g., protection against divide by zero deep inside the equation if the wrong set of parameters are input), or by having an additional sanity check on the value that's about to be output to an actuator given current conditions. The point here is to acknowledge that an unseen defect may be lurking in the code, and to try to add protection against it.
There are also predictive techniques that a lot of groups use to estimate defect density. If you expect (based mainly on history) that there will be 1 defect/kLoC found in final test and the test team is only finding 0.1 or they're finding 10, then you need to go back and figure out if the estimates are wrong, the design is screwed up, or the testers are slacking off. In any case, the process should be adjusted.
I don't know when software development will get to the statistically predictable state of modern manufacturing, but it will happen eventually. At least in the bits that are important enough.