I wish luck to everyone buying these things. You'll need it to run any modern distro in a few years.
I wish luck to everyone buying these things. You'll need it to run any modern distro in a few years.
Only to realise that lack of software support makes them almost all pretty much completely useless.
I wouldn't use any randomly bought ARM device now for hobby projects, except the Raspberry Pi.
2.) Boot is only possible from microSD card. USB is not supported.
3.) Build BareBox with https://www.barebox.org/doc/latest/boards/rockchip.html
Use `rk-splitboot` to split FlashData from the original boot loader, other option doesn't work. Build it, it will create barebox-radxa-rock.img. It's .img, not the .bin.
Write an SD card as in the instruction.
4.) Follow these instructions, but use the generic image.
https://archlinuxarm.org/platforms/armv7/amlogic/odroid-c1
http://os.archlinuxarm.org/os/ArchLinuxARM-armv7-latest.tar....
5.) Build kernel as in this tutorial, ignore the `dts` stuff. The `dts` comes with the kernel sources.
https://wiki.radxa.com/Rock/Linux_Mainline
https://github.com/torvalds/linux/blob/master/arch/arm/boot/...
6.) Copy the zImage, rk3188-radxarock.dts to the /boot and plug in the UART.
7.) sudo picocom /dev/ttyUSB1 -b 115200 -e w
8.) Boot in the bootloader and execute the following commands:
global.bootm.appendroot=true
global.bootm.image=/mnt/mshc1.0/boot/zImage
global.bootm.oftree=/mnt/mshc1.0/boot/dtbs/rk3188-radxarock.dtb
bootm
9.) If it boots, you can make it permanent by following the BareBox docs.
I find it gets unstable with cheaper USB C chargers.
I specifically buy high quality chargers/cables/battery packs for my embedded work since they are so intolerant of bad power