Are these parts functional? I would be literally stunned if you could 3D print a bolt carrier group that lasts more than a clip.
The last I looked (and it's been a couple years), the designs exist, but are largely non-functional and/or still require several parts to be made of steel.
The barrel is another problematic piece. I get that with enough plastic, you might be able to make it handle the pressure (and that's a pretty big might). Even presuming you do, plastic is not hard enough to allow rifling, so we're back to smoothbore rifles, which practically haven't been seen since the Civil War. Worse yet, every time you pull that trigger, the heat and pressure will blast more of your plastic out the end of the barrel. That's going to ruin your accuracy, and at a certain point, you'll start losing muzzle velocity because the barrel no longer seals around the bullet.