Here's a list of terms for reference: http://data-recovery-tips.co.uk/wp-content/uploads/2013/09/h...
At some point, the bearing that serves as the pivot that the actuator arm and actuator attach to, is attached to the chassis of the hard drive with a bolt on the bottom of the drive. At that time, most drives also had a bolt that went through the cover. The Deathstar did not. It was only attached to the chassis. Which was fine, and that's the method commonly used since then. This particular drive had no thread lock on the bolt, and it had come loose, leading to a catastrophic head crash.
I don't know if other Deathstar's suffered the same fate for the same reason. The Wikipedia article on the subject says it was due to the magnetic coating of the platters coming off.
We'd open the case of a crashed cartridge, extract the platter, and hang it on the wall; the crash would produce a rather spectacular sunburst pattern in the magnetic coating.
I always thought hard disk platters looked especially cool compared to other storage media like floppies or CDs or flash stuff.
So I submitted the article: https://news.ycombinator.com/item?id=27423640
https://r-1.ch/hdd.mp3 (warning, loud)
https://soundcloud.com/ryan-flowers-916961339/sets/hard-driv...
The associated blog post: https://miscdotgeek.com/adventures-in-hard-drives/