So when someone writes an article saying "it's stronger than steel!" that's exciting, but it's not enough information. In this case we know it's stronger by yield strength. We can say the new material's yield strength is twice that of the weakest known steel alloy, but no more than that.
A quick look around found this:
https://amesweb.info/Materials/Steel-Tensile-Yield-Strength-...
You can see here, there is a wide gulf between the weakest and strongest alloys just in this chart, which only has five alloys and a handful of different treatments. Yield strength is anywhere from 210MPa to over 1600MPa, an 8x difference.
This page has some charts for the new material:
https://www.researchgate.net/figure/Mechanical-properties-of...
Subchart (g) in the image shows a plot of yield strength against elastic modulus, and it looks like the plot tops out around 1.4 GPa, meaning the strongest tested configuration by yield strength is weaker than that of tempered 4140 and 4340 steels, while nearly 7x stronger than hot-rolled 1020 steel. I don't know if "2D yield strength" is different than what is shown in the amesweb.info table, though.
That's not yield strength.
Yield strength is how much force is required to permanently deform the material.
Ultimate tensile strength is the force required to break the material.
One great thing about steels is that they tend to work-harden.
Typical 250 grade mild steel, meaning it takes in excess of 250 MPa force to permanently stretch a 10mm round diameter section, usually has an ultimate tensile strength exceeding 400 MPa.