IIRC turbomolecular pumps, which are used for deep vacuum applications, have a large intake area and work by basically spinning a huge array of blades at very high speed to bat the individual gas particles out of the working volume into progressively higher pressure areas, ultimately pumped out by a conventional pump.
An ion pump (also referred to as a sputter ion pump) is a type of vacuum pump which operates by sputtering a metal getter. Under ideal conditions, ion pumps are capable of reaching pressures as low as 10−11 mbar.[1] An ion pump first ionizes gas within the vessel it is attached to and employs a strong electrical potential, typically 3–7 kV, which accelerates the ions into a solid electrode. Small bits of the electrode are sputtered into the chamber. Gasses are trapped by a combination of chemical reactions with the surface of the highly-reactive sputtered material, and being physically trapped underneath that material.
I was reading about early Royal Society proposals for flying machines that were based on vacuums in copper balloons. Can any material at any size support a vacuum that can displace the weight of the material? (ie, and thus support lighter than air flight via vacuum)
Hydrogen is already nearly a vacuum from a lift prospective (it’s only about 5% as dense as air at the same pressure).
Nature really abhors a vacuum.
The question is: does maintaining this require a very high vacuum to replace/maintain the working fluid. Its one of those scaling problems where you have to spend ten times as much to get to the next ten times less gas in a vessel (or thereabouts) and an absolute complete vacuum is more or less impossible.