> MIDI is simple enough to trigger something with a single pin going high low.
MIDI is not high / low but current on / current off.
MIDI is not high / low but current on / current off.
But it is correct that the current which ends up flowing through the connection is what determines the bits sent (by virtue of the receiver being an optocoupler, not an op-amps).
[1] https://midi.org/specifications/midi1-specifications/midi-1-...
(thx, I didn't knwow about required independence from the ground)
(In this way, two connected MIDI devices can have different ideas of what signal ground is without causing issues.)