Get a cable tester and see what the cable type/qualtiy and signal characteristics are. Or if you're near some other equipment that is high-EM (where shielding may be needed).
There is nothing theoretical about the official numbers with a quality install:
* https://en.wikipedia.org/wiki/Ethernet_over_twisted_pair#Var...
In the ISO/IEC structural cabling standard the length is strictly informative, and the length of a cable/run doesn't matter as long as the signal characteristics are good: you can have a 130m run and a tester will not pass-fail based on the length, but on the signal quality:
Given that it's not even ratified yet… no.
Does it have problems on single unbroken cable like that or it just has few patch-panels along the way ? IIRC the standard was for 100m unbroken cable, not the usual of device -> cable -> patchpanel -> cable ->patchpanel -> cable -> patchpanel -> cable -> device
* https://www.youtube.com/watch?v=kNa_IdfivKs&t=11m48s
* https://www.truecable.com/blogs/cable-academy/maximum-ethern...
With the ISO standard the length is strictly informative, and the length of a cable/run doesn't matter as long as the signal characteristics are good:
Also, AIUI, having the electrical isolation between the 2 buildings is nice.