This method saves blasting the IC with hot air while heating up the whole lot.
This method saves blasting the IC with hot air while heating up the whole lot.
Instead of using a solder-stencil to deposit a carefully calibrated amount of solder onto any location, you can buy a solder-paste syringe and squeeze the solder-paste into place.
This almost *always* results in too much solder, because its a hand application process, and its often better to have more-solder + cleanup than too little solder in my experience.
-----------
https://www.amazon.com/Solder-Bi57-6-No-Clean-Lead-Free-Temp...
Obviously if you had perfect hand-control (ex: a solder paste robot... or a solder stencil, or other methodology), that's preferred.
But if you're doing these cheap designs you'll need to plan for the "too much solder" situation. In fact, "too much solder" is the default choice and quite fine, albeit with a simple cleanup step. (Ex: swish around a small piece of solder wick in my experience while the solder is still hot, or while the solder-wick is touching a soldering iron, etc. etc. Plenty of cleanup methods available).
Do it dirty then clean-up is just the default mode of operation in hobby-level manufacturing / solder paste / soldering. Its surprisingly effective.
Its super easy to grab a toothpick and pull out excess solder paste on a per-pad basis. Just do it before you heat the board up (solder paste is applied cold, so there's plenty of time to "correct" things if they look bad).
The "problem" is that this whole exercise is an unnecessary waste of time in my experience. Just live with the excess solder and solder-wick it up at a later point. Swishing around a solder-wick is way easier than tooth-picking the solder-paste on each pad to the right size.