The 3D printer community is oddly resistant to step files. They claim that step files get converted to STL and therefore it doesn't matter. Except there is an obvious problem with this argument. First of all a mesh isn't an STL file, second the printer can adapt its mesh generation based on your slicer settings so that it always has a high enough resolution. Third, the mesh generator can adaptively generate high resolution meshes in complex geometries and low resolution meshes at simple geometries in the same part. Fourth importing step files generates G code with arcs which speeds up printing time.

https://www.reddit.com/r/BambuLab/comments/w15mg6/improvemen...