why would it be earth shattering?
(tr)usdx has ssb support for a similar price and the internal microphone actually works. It also has a digital interface (a bit unstable at times though) for digimodes without neding soundcards and aditional cables.
why would it be earth shattering?
(tr)usdx has ssb support for a similar price and the internal microphone actually works. It also has a digital interface (a bit unstable at times though) for digimodes without neding soundcards and aditional cables.
Hans (the designer) is an amazing developer and very thorough, and his kits are very high quality. He includes several diagnostic tools in his firmware, so you don’t just build a kit, but you can diagnose and tune the performance with the kit itself. A beta release from Hans is practically a release candidate in everyone else’s eyes because he’s so thorough.
In terms of functionality, this SSB mode means you can do practically any modulation now, where previously you could only do single frequency fixed amplitude modes. So now you can do PSK, winlink, SSB voice, and whatever modes become popular in the future.
Hans took a while developing this because he wanted to get the max performance from the tiny ~5W transmit power, so he implemented a technique called controlled envelope SSB which was clearly challenging to get right, and I’m not sure the (tr)usdx even has the processing power to implement it.
I’ll probably buy another kit because of this just because I’m so excited (I built a QMX+ last year). This makes the QMX a really good radio. It has always been high quality, it was just held back by only being able to do CW and a certain digital modes. Being able to do voice and ALL digital modes at this price range and quality is unbeatable.
Gifted embedded software, but the electronics is simply not that robust. The company could really use an electrical engineer to complement its software engineer.
Overall, the kit is still a killer value and buildable by someone who can follow directions and is decent at soldering. This is in stark contrast to many other kits which require a lot of sleuthing to figure out issues because the instructions aren't clear, or they changed some components and didn't update their documentation. And these other kits often don't have any better design for their power management sides either.
There have been a few board revisions to address some of the bigger issues that have come up with early board spins, and I like that mods have been made public for most of the early builders to keep their kits working.
The most common problem seem to be blown transistors from transmitting into a mismatched load, and that is mostly the operator's fault and common in many radios. I like that Hans put some SWR protection in the QMX to keep the finals from blowing as often as they might.