Sparkfun does a really good job of making their kits easy. If you look closely at them, the boards that require diodes and electrolytic capacitors have a picture printed on the pcb that make it really obvious what the polarity is. The gertboard pcb doesn't have any of these. If you solder a led backwards, you're SOL. So if you haven't seen a diode or led before, you probably shouldn't pick the gertboard as a first project.
You can buy the arduino as a kit, but most people who are just starting out with electronics will get one prebuilt so they don't accidentally stick their atmega chip in backwards.
http://www.element14.com/community/themes/images/raspberrypi...
See this larger picture:
http://www.raspberrypi.org/wp-content/uploads/2012/08/image0...
Or read the assembly manual where they teach how to solder surface mount components. There's a bunch of resistors & capacitors all over the board that happen to be surface mount.
http://www.element14.com/community/servlet/JiveServlet/downl...