The SATA spec defines "pre-charge" voltage pins that are connected after ground, but before any of the other voltage pins are connected. The idea is that by inserting a small (10 ohm) resistor, you can limit inrush current to a tolerable value while capacitors charge and regulators start up, and then when the other pins connect a couple of milliseconds later, the drive gets the proper low-impedance power connection.
Do you know if implementing pre-charge via connector mechanics obviates hot-swap protection circuitry? Supermicro seems to have hot-swap protection on their backplanes as well, but I haven't had a chance to closely inspect it.