Hacker News Reader

It seems like not quite.

The width is 50 some inches but the wheel wells are there so you may need some 2x4 or something to keep plywood from flexing over them. And the length of the bed isn’t near 8 feet so you’d need the bed open and the boards strapped in.

This jalopnik article had some helpful measurements: https://www.jalopnik.com/1845231/slate-pickup-bed-fit-every-...

Not flat between the wheel wells (42.9"), but on top of them. There's a photo (don't know if it's real though).

https://www.slateforums.com/forum/threads/slate-truck-dimens...

Easily found: https://www.slate.auto/en/specs

None of that seems to answer my question.

Detailed dimension specs are.. right there.

Your other question is about.. bed vibes? That's not a real spec (for any truck builder). You can put a 100x4 sheet rock in any 4'+ wide bed.. best of luck to the person behind you. Don't forget the red flag (day) or light (at night).. in north america.

Only the bed length is listed there. It’s insufficient data to determine whether a full size sheet of plywood will fit.

the bed is listed as 5 feet long, and the entire truck a bit under 6 feet wide. so I don't think you can get something thats 4x8 feet to lay flat.