Most cabling in a studio is bulk copper wire from a giant spool, permanently soldered in place for reliability.
The only plugging happens at dedicated patch panels, which in my experience are old repurposed analog telephone patch bays that look as old and corroded as they are.
Gold connectors are for home enthusiasts with money to burn. The practical effect of the platings are so far below the noise floor (vs ground loops, EMF, amp noise) that it's irrelevant for audio work.
I've never seen a gold-plated XLR cable, which is usually the first link in every studio recording chain.
[1] - Douglas Giancoli (2009) [1984]. "25. Electric Currents and Resistance". In Jocelyn Phillips. Physics for Scientists and Engineers with Modern Physics (4th ed.). Upper Saddle River, New Jersey: Prentice Hall. p. 658. ISBN 0-13-149508-9.
[2] - Raymond A. Serway (1998). Principles of Physics (2nd ed.). Fort Worth, Texas; London: Saunders College Pub. p. 602. ISBN 0-03-020457-7.
Gold, however, is much more resistant to oxidation.
And we all know, there's no difference between the $150 hdmi cable and the $5 hdmi cable except cosmetics and perhaps some better shielding. They're all digital connections, so the signal/bits are either there or are not.
Absolutely not true. There is quite a lot of engineering behind making an HDMI or Ethernet cable work:
http://en.wikipedia.org/wiki/Transmission_line
And, there are plenty of ways to mess it up and make a cable that only sort of works.
TMDS, the signaling mechanism that HDMI uses, does not have error correction codes. It does do some error detection by using 10 bits to transmit each 8 bit message and declaring some of the binary representations "invalid", but if the cable does not work well, you will get visual artifacts. (I was surprised when I saw this; little specks of green among blacks while I was running an HDMI cable very close to its maximum bandwidth. One video card I tested refused to output anything, but another was happy to send a signal that was corrupted by the cable.)
Further reading:
I don't see your point, because it seems to back my earlier point.
What digital signaling does is fix some common failure modes of analog. The signal is balanced, so it's more immune to picking up and emitting noise. The electrical signal only has two defined states, so if you degrade the signal in some way (attenuation, noise), you'll probably be able to pick the right state. But, you don't get infinite ability to do that, only more. Eventually, the two states become indistinguishable, and then you can't tell which bit was transmitted to you. (But you can't tell that you can't tell, so you start picking bits at random.)
If we take this to the logical extreme, your argument implies that you can build an infinitely long cable with an infinitely tiny amount of material.
It's fairly common... Samsung makes almost all the parts of the Best Buy store-brand TV's... they're essentially a slightly lower-grade samsung tv with the store-brand slapped on and sold cheaper.
> ANJOU interconnects employ ultra high purity (99.99%) solid gold conductors. It is extremely important for interconnects to maintain a smooth, impurity free conductor surface to maintain signal integrity. Both copper and silver conductors corrode in air over time creating a thin layer of either copper oxide or silver sulfide. Both of these contaminants have vastly different electrical properties from their metallic counterparts, which will cause signal distortion in interconnects. All dielectric materials, including Teflon, are permeable to oxygen, which means that over time, the copper or silver conductors will become damaged. This is especially problematic at the termination ends where heat is frequently applied from resistance welding or soldering.
Etc etc.
There is gold in a few more places in a CPU, typically the bonding pads surface and the wires connecting them to the pins.
It is quite possible the skin effect is at play here and that gold's superior resistance against oxidation is what gives it an edge. (we're talking GHz after all!).