R4 and R5 are 0K resistors. 0K resistors actually exist, and are typically used in place of short pieces of wire. The advantage of a 0K resistor over a short piece of wire is that they can be picked and placed and soldered using the same equipment that handles resistors, thus saving the need of having a separate machine for short wires.
That is how they are being used here, as you can see from the layout diagram. R5 is used to carry the RST signal over another line on the board, and R4 serves the same function for VCC.
First question: should these even be included on the schematic? They only exist to work around a construction limitation due to the use of a single layer PCB. If the circuit was built on a two layer PCB, or a breadboard, or wire wrapped, there would be no 0K resistors needed. I thought that schematics were supposed to just convey the topology of the circuit, leaving things related to the practical difficulties of construction to other documents (like the layout diagram).
Second question: on the schematic, why is R5 shown as connecting RST to RST, but R4 is shown as connecting VCC to itself? They are both being used to take a line across another line, so why aren't the both drawn the same way on the schematic?