1,069 karma · joined January 20, 2026
Second off, I didn't call the whole audience "sneering POS's". I only implied it. Regardless of whether they're 5% or 50% those types are sufficiently plentiful in the comments, here and elsewhere, such that anyone posting stuff that's against the grain will be quickly predated upon by them unless their take is hedged in a nearly airtight manner.
That said I consider the rationalists a little bit higher brow since they're at least DIYing (or were before AI) the words and the arguments and responsible for all that verbosity whereas any idiot can cherry pick links.
Basically it's a defense mechanism against adversarial HN commenter type behavior that's been cargo culted a couple times over and doesn't actually service it's original purpose anymore and is just a group signaling mechanism.
With the massive extra "pro" of plausible deniability so all those who's interests are served by it can lie up down and sideways about how it's a good thing.
A lot of things are like this. It's really hard to overstate the cost of laying unpopular things bare.
Having some slimy Mitt Romney types doing math about various state industries and interests when wording bills and trading votes would be a huge improvement over the equally slimy jerks we have now scheming up ways to serve their donors (who's interests correlate with the voters even less than the state's despite that bar being low to begin with) while leveraging abortion this guns that wedge issues to get re-elected despite screwing their voters.
The distribution of senators to states would also matter less if they weren't direct elected and therefore as beholden to party platforms and funding systems and whatnot.
Obviously there's a lot more nuance and detail to it (the blame Nixon deserves being of specific note IMO) but the argument is there.
So I'd argue that both the means are bad and the end
The rust belt cities are not victims of technical change. They are victims of political whim. It was decided decades ago that a steel mill in the far east is superior to one a few miles outside of Cincinnati.
That would be what normal people would call a "bold faced lie" in normal conversation and is only above average levels of misleading compared to what's typical around here (which reflects upon the character of the people on HN, IMO).
A sherman is approx same length as the biggest modern SUVs but wider, taller and 10x the weight.
You may as well compare rowing shells to fishing vessels.
The best selling car of the 90s was consistently a Taurus and yet everyone who grew up riding around in one or learned to drive in one or had one as a first car in the 00s is nostalgic for whatever Toyota product their rich AF friend's stock broker/surgeon dad was driving around then.
https://starecat.com/content/wp-content/uploads/bmw-grille-c...
(pretty sure that's not the original but you get the point)
It only works for idling trucks because the person letting the truck idle is almost never the owner and the person idling the truck is usually doing work so they're not around to notice they're being reported and there's a lot more public apetite for enforcement against businesses than the general public and they write it off as a cost of doing business.
If you open up the floodgates of anyone v anyone that generic parking enforcement entails I give it about a week before some "super reporter" gets curb stomped by an uber driver who's having a bad day. And then you'll have public scrutiny, the tough question that come with that and the entire program is likely to be walked back as a result.
Regardless, the typical outlet is not GFCI protected just due to the math of volume of new construction vs old construction vs service life. We're probably close to 50% coverage in new builds, more in low room count/wall area apartments. Tamper proof outlets are a better solution for this non-problem anyway.
Most people in the US will go their whole lives without having an issue related to this or knowing anyone who did. This is one of those problems that mostly only exists as a post-hoc justification for an already held belief.
The way those old outlets work is you get two hots and a ground. No neutral. This is fine for simple appliances that run wholly on 220v and utilize mechanical controls (so like all old appliances) but as you start adding complexity in the appliance you start wanting to use 120v control circuitry stuff (i.e. a cost saving hack by the device manufacturer) and this opens the door for the appliance to be live at 120v if the case is bonded to the ground and your ground wire in the cord is broken. Or it opens the door for the case of the appliance to be floating and live at 120v if there's a short to it.
With appliances manufactured for global markets these days that accept all manner of input voltages and run any controls off of some DC powered circuit board this isn't really a problem anymore but with the way people worship rules like religion I'm sure in the year 3026 we'll still be reading comments like yours.
Or it might be one of those cases where the discretionary BS you can be put through is so onerous and capricious that the cheapest way to get it done is to bulldoze first, let the threats fly and use whatever legal maneuvering that gets you to wind up with a more favorable venue (the higher up you go the more friendly to industry permitting authorities tend to become).
That said, it drives me up the wall that it seems like all the bad managers are exactly like the one you're experienced.
Being too bulky to engage in overseas shipping shenanigans probably helps it.