2,350 karma · joined April 15, 2013
What that means for the clerks trying to regulate the ad business... Well...
Sigh.
Just stop subsidizing large businesses, revert regulatory capture and give incentives to start new businesses as coops for instance.
I get that most people have been brought up in the "greedy by default" mode, but that's no excuse to give up and just transact ourselves to oblivion.
Let's rediscover different ways of association.
It does, though. Same shit can be seen everywhere. Food for profit? Addictive poison. Health for profit? Ineffective care with prolonged suffering and excluded populace. Cars for profit? Emission cheating, subscriptions. Farm equipment for profit? War on independent repair.
Profit motive worked when the market was regulated, there were not many monopolies, excessive profits were progressively taxed, research has been sufficiently well funded, worst jobs were outsourced to colonies and most importantly markets were not saturated and there was an organic demand for new and better products.
One can frequently see an 6.3V 22uF to 100uF SMD tantalum capacitor being used for the bulk capacitance right after the DC-DC converter. Closest MLCC you can buy is 25V 22uF X7R, which costs slightly more and provides less capacitance (even when comparing 22uF nominal) with further loss due to aging. I have yet to see 100uF MLCC.
Not all designs strictly require them, though. When for example dropping 5V to 3.3V using an LDO, having all components decoupled well enough locally, you might get by without bulk capacitance. Some boards are large enough for electrolytic caps that can be combined with ceramics to get you close.
Also, you might be interested in this: https://youtu.be/1NqRbBvujHY?t=2236
What Kalman filter does is that it estimates your position and then averages measurement with that, in essence bringing the value closer to where you are at the moment.
Having a delay in a feedback loop may cause oscillations. If you react way slower than you measure, you might not need Kalman filter. Proposed GPS example is relevant here, because position updates come in slowly.
Overwhelming majority of mains-powered devices does, in fact, have a transformer. It is part of a switched-mode power supply, though. The only devices that do not have one are those that are fully enclosed in plastics and user can not under any circumstances come to contact with any of the conductive parts. Typical example would be a LED light bulb or wall-socket powered WiFi repeater (without RJ45 port).
It is pretty hard to create a transformer-less device using plain rectifier/switch/capacitor topology. The biggest issues obviously are the high voltage before the switch and dead time when the mains voltage drops near zero 100 times per second. Most switch ICs made in the "west" cannot go up to 325V and are thus usually used with a transformer to step the voltage down below 60V. If you get a Chinese chip that can work off-line (as in directly with the 325V mains voltage), such as KP1063 <https://datasheet.lcsc.com/lcsc/2103171532_Kiwi-Instruments-...>, it still needs an inductor to bridge the mains dead time. This is incidentally done by the transformer in traditional power supplies. Capacitor would have to be huge to smooth over those for any significant power draw.
> If we increase the voltage across the wires to 120V and down-convert that to 12V at the computer we'd only need to conduct 1A and the wire loss would be 0.5V, which at 1A is a power loss of 0.5W. That's completely acceptable, and because the computer down-converts anyways we don't really have to care about it getting 119.5V instead of 120V either.
We could use 48V, which would bring the cable losses to about 3.3W (for those 100 ft). Or maybe instead of wiring from the mains box, we would place transformers along the wall sockets. Some new installations already do that and install charging USB ports. USB-PD is now specified up to 48V / 5A.
I think that we are already seeing devices abandoning the traditional DC connectors in favor of USB. A lot more people now have a large bank of charging USB-A and USB-C ports on their desks. Some vendors already integrate them in extension cords. It won't take long for LED lamps to come with an USB cord and an optional mains/USB transformer SMPS ("phone charger"). Laptops are already charging (and docking) via USB-C with PD, it might not take long for screens to follow.
Stepping 48V DC down to 12V, 5V, 3.3V is way easier and can actually work the way you have described above.
Why don't we have a law that says "if the boss is disrespectful to the worker, they pay the worker the average of their hourly wage for every such incident" while being rude to your superior would be considered a breach of conduct that, when repeated, would be grounds for dismissal?
Stop adoring the hierarchy and licking the boot.
It will be swiftly adopted by well meaning but clueless bank and government clerks who will accidentally use to lock all open hardware, open operating system, open browser users out and mandate you need to purchase at least one locked down corporate device to exist.
It's the trusted computing story all along. Eventually you will need permission to run your code on your own device and such "unlocked" device will be blocked from accessing any digital infrastructure because it might be otherwise used to breach ToS.