I did the drawings of several drones and robot arms, and accurately computed the needed torque. I target specific precisions for several applications.
I’m a mathematician so the math is straightforward to me though as you said, it’s super easy to overlook something without the appropriate experience, especially since it’s cross disciplinary (ME, EE, SE… etc. All at once yeah!)
I found these for instance on eBay:
* https://www.ebay.com/itm/393967889048
* https://www.ebay.com/itm/275442630163
I can get from them more than 120Nm with the appropriate planetary gearbox without sacrificing too much speed and even more with gas springs compensating the static loads… theoretically… but I’m a bit skeptic about the announced 12Nm and the 51200microsteps/rev resolution for instance.
I think it’s better (in my case) to have access to maximum IO on the encoder side.
I’ll double check the electrical installation with a pro for sure, I already did a mistake in the past that almost destroyed the house boiler in the middle of the winter… lesson learned.