I had a not-so-fun troubleshooting session this week trying to figure out my ADC wasn't working on an STM32H7 board, but works fine on G4. It turns out there's a `boost` bit in on the registers that has to be set on H7, if the ADC clock speed is >20Mhz... which is is at most common settings. Other than that, the ADC config is the same as other STM32s. That was frustrating! RTFM and don't make assumptions. Another trap is that on H7, the ADC's default clock isn't enabled; requires turning on the second PLL, or re-configuring the first one.